Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

PowerProtect Data Manager 19.10 Administration and User Guide

Enable backup and restore encryption

You can ensure that the backup and restore content is encrypted when read on the source system, transmitted in encrypted form, and then decrypted before it is saved on the destination storage.

Prerequisites

Review the information in Backup and restore encryption to learn more about backup and restore encryption.

The encryption settings determine if the data transfer is encrypted while in-flight during backup and restore operations.

  • For Microsoft SQL Server, Microsoft Exchange Server, File System, SAP HANA, and Oracle workloads, backup and restore encryption is only supported for Application Direct hosts.
  • When a new host is added to PowerProtect Data Manager, host configuration is run to push the encryption settings to the host.
  • Only hosts that have the same version of PowerProtect Data Manager application agents installed support the host configuration.

About this task

Steps

  1. From the PowerProtect Data Manager UI, click Settings icon, and then select Security.
    The Security dialog box appears.
  2. Click the Backup/Restore Encryption switch so it is enabled, and then click Save.

Next steps

The Jobs > System Job window of the PowerProtect Data Manager UI creates a job to enable protection encryption. This job pushes encryption settings to the hosts to be used for self-service operations. Within the system job, a host configuration job is created for each host. If an error occurs, you can retry the system job or individual host configuration job.

NOTE For centralized backup and restore operations, PowerProtect Data Manager sends the encryption settings to the application agents on the Application Direct hosts and network-attached storage (NAS).

You can disable encryption for backup and restore content by clicking the Backup/Restore Encryption switch. PowerProtect Data Manager creates a system job in the Jobs > System Job window to disable protection encryption.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\