Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

PowerProtect Data Manager 19.10 Administration and User Guide

Ifgroup configuration and PowerProtect Data Manager policies

If an ifGroup is configured on the DD, the IP address selected in the PowerProtect Data Manager protection policy is only used for the initial connection, and redirection (for example, for load balancing) occurs according to the ifGroup setting on the DD. LACP and other failover options on the DD work independently from what is selected in the PowerProtect Data Manager policy.

The following examples and diagrams demonstrate common scenarios in PowerProtect Data Manager when an ifGroup is configured on the DD.

PowerProtect Data Manager policy with no ifGroup

DD configuration:

  • eth1/eth2 1G
  • eth3/eth4/eth5/eth6 10G
  • No ifGroup
ifgroup config example one

PowerProtect Data Manager policy with one ifGroup

DD configuration:

  • eth1/eth2 1G
  • eth3/eth4/eth5/eth6 10G
  • ifGroup * eth3/eth4/eth5/eth6
ifgroup config example two

PowerProtect Data Manager policy with multiple ifGroups

DD configuration:

  • eth1/eth2 1G
  • eth3/eth4/eth5/eth6 10G
  • ifGroup VLAN-VM eth3/eth4
  • ifGroup VLAN-SQL eth5/eth6
ifgroup config example three

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\