PowerProtect Data Manager 19.10 File System User Guide

PDF

Add NIC or disk drivers to the custom WinPE image

You can modify the custom WinPE image to add NIC or disk device drivers so you don't have to use a separate disk during the BMR.

About this task

If the custom WinPE image does not provide NIC or disk device drivers for the source host, you add them to the image.
NOTE Modifying the image in any way other than adding NIC or disk device drivers is unsupported.

Steps

  1. Open the .iso file of the WinPE image with a utility like UltraISO or MagicISO.
  2. Create a folder for the drivers at the top level of the folder structure. The following example creates a Drivers folder.
    Figure 1. WinPE folders. WinPE folders
    Folders
  3. Copy the NIC or disk device drivers to the folder.
    If you have different source hosts that require different NIC or disk device drivers, you can create a subfolder for each device driver.
  4. Save the WinPE image with a different name.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\