PowerProtect Data Manager 19.10 File System User Guide

PDF

Configure the client to boot into Directory Services Restore Mode

Before you recover the Active Directory from disaster recovery data, configure the client to boot into Directory Services Restore Mode (DSRM).

Steps

  1. Run the msconfig command. The System Configuration window appears.
  2. On the Boot tab, select Safe boot, and then select Active Directory repair.
  3. Click OK.
  4. Restart the computer into Directory Services Restore Mode (DSRM).

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\