PowerProtect Data Manager 19.10 File System User Guide

PDF

Install the File System agent on Linux in silent mode

On Linux, review the following commands to perform a silent installation of the File System agent.

NOTE

The --server option is used to specify the PowerProtect server IP for registration, and is mandatory for silent install.

To verify the authenticity and integrity of the RPM files prior to the installation step, follow the instructions in the PowerProtect Data Manager Security Configuration Guide.

Use the following commands to perform a silent installation on Linux:

  • For silent installation, including registration of the agent with the PowerProtect server, type: install.sh --silent-install --server=<PowerProtect_server_IP>
  • To run the installer in debug mode during silent installation, type: install.sh --debug --silent-install --server=<PowerProtect_server_IP>
  • To skip installation of the block-based backup driver, type: install.sh --skip-driver --silent-install --server=<PowerProtect_server_IP>.
  • To enable the PowerProtect Data Manager communication 7000 TCP port, run the /opt/dpsapps/agentsvc/configfw.sh script as the root user.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\