PowerProtect Data Manager 19.10 SAP HANA User Guide

PDF

Recommission the SAP HANA agent

Learn how to recommission the client with the SAP HANA agent.

NOTE With a PowerProtect Data Manager version earlier than 19.8, you cannot use the following method to recommission the client to the PowerProtect Data Manager server. You must uninstall and reinstall the client software and then register the client with the required PowerProtect Data Manager server.

When the client with the SAP HANA agent has been decommissioned, use one of the following methods to recommission and register the client with the PowerProtect Data Manager server:

  • To continue with the same version of the client, run the ppdmHanaInstall.sh command to register the client with PowerProtect Data Manager.

    NOTE If you specify a hostname or fully qualified domain name (FQDN) with an underscore (_) for the PowerProtect Data Manager server, then the communication will be done by the system's IP, if provided by the system on registration.
  • To update the client and also register the client with PowerProtect Data Manager, run the ppdmHanaInstall.sh -u command.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\