- Notes, cautions, and warnings
- Preface
- Getting Started
- Preparing for a Deployment
- Deployment
- Configuration
- Configure the PowerProtect Data Manager virtual appliance
- Configuring network traffic rules
- Configuring DDVE and storage
- Configuring and monitoring system health
- Configuring disaster recovery
- Deploying SupportAssist to Azure
- Using SSH
- Access the PowerProtect Data Manager UI
- Updating PowerProtect Data Manager
PowerProtect Data Manager 19.11 Azure Deployment Guide
Updating PowerProtect Data Manager
When a new version of PowerProtect Data Manager is released, you might want to use the newer version in your cloud environment.
The following general procedure should be followed when updating PowerProtect Data Manager:
- Back up the
PowerProtect Data Manager virtual appliance. For instructions, see the documentation provided by the cloud provider.
NOTE Backing up the virtual appliance allows you to restore it in the event that the update fails.
- From PowerProtect Data Manager, install the update package for the new version. This update package is installed in the same way as in an on-premises installation.
For detailed instructions, see the PowerProtect Data Manager Deployment Guide.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\