PowerProtect Data Manager orchestrates protection policy replication
objectives independently of the primary backup or retention. When you add a replication
objective to a policy, select one of the available triggers.
The default replication trigger is a schedule window that you define by setting a recurrence period plus start and end times. Replication occurs during the defined window. For example, every day between 8 p.m. and 12 a.m.
You can also trigger replication immediately after the completion of the associated primary backup or retention, whether scheduled or manual. At the start of the primary backup,
PowerProtect Data Manager generates an associated replication job that remains queued until the end of the protection job. If the backup fails or completes with exception, the associated replication job is skipped. Restarting the protection job queues the associated replication job again.
NOTE
Replication after backup completion is only supported for centralized protection policies. This feature is not yet available for self-service protection policies or for replication
objectives that are based on extended retention.
Older application agents may not support replication after backup completion. Update the applicable application agents to the current version before configuring this trigger.
Using a schedule can help you manage network traffic by replicating during off-peak hours. However, for larger backup sets, the primary backup or retention may not finish before the start of the replication schedule, which creates a replication backlog. Replication after backup completion prevents a replication backlog from forming.
To prevent data loss, the replication after backup completion trigger replicates new backups from the primary
objective and any outstanding backups that have not yet replicated.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\