If you enabled an asset source that you no longer require, and the host has not been registered in
PowerProtect Data Manager, perform the following steps to disable the asset source.
About this task
NOTE An asset source cannot be disabled when one or more sources are still registered or there are backup copies of the source assets. For example, if you registered a vCenter server and created policy backups for the vCenter Server virtual machines, then you cannot disable the vCenter Server asset source. But if you register a vCenter server and then delete it without creating any backups, you can disable the asset source.
Steps
From the
PowerProtect Data Manager UI, select
Infrastructure > Asset Sources, and then select the tab of the asset source that you want to disable.
If no host registration is detected, a red
Disable button appears.
Click
Disable.
Results
PowerProtect Data Manager removes the tab for this asset source.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\