PowerProtect Data Manager 19.14 Amazon Web Services Deployment Guide

PDF

Configure network traffic rules

Configure network traffic rules to restrict inbound and outbound connections.

About this task

CAUTION:Do not use IP addresses that belong to the 172.24.0.192/26 subnet. IP addresses in the 172.24.0.192–172.24.0.255 range are used for Docker network configuration, and unexpected results can occur if they are also used by PowerProtect Data Manager.

Steps

  1. From the EC2 Instance Management Console, click the security group shown after Security groups, and select either Actions > Edit inbound rules or Actions > Edit inbound rules.
  2. From either the Edit inbound rules pane or the Edit outbound rules pane, change specific network traffic rules.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\