PowerProtect Data Manager 19.14 Deployment Guide

PDF

Manually check for an update package

You can use the PowerProtect Data Manager user interface to manually check for a new update package.

Prerequisites

SupportAssist must be enabled. For more information, see Configuring SupportAssist for PowerProtect Data Manager and Enable or disable SupportAssist.

Steps

  1. Log in to the PowerProtect Data Manager user interface as a user with the Administrator role.
  2. Click Settings icon, and then select Software Update.
  3. From the Software Update window, click Check for Updates.
  4. From the Software Update > Check for Updates pane, click Check Now.

Results

All available update packages are displayed in the Software Update > Check for Updates pane. If there is more than one update package available, more information about each can be seen.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\