You might encounter the following issues while performing restores with the
File System agent.
File-level restores of symbolic-linked directories
The file-level restore of a symbolic-linked directory does not contain any symbolic links or reparse points, but the contents are the same as the source directory.
Create symbolic links manually after the file-level restore operation completes.
File-level restore operations fail with a client services error
When performing a file-level restore, you might see an error similar to one of the following:
Resource not found. Check if client services are running and perform the operation again.
ARA0002: Unable to restore FILE_SYSTEM asset F:\ because of an agent issue.
The restore was unsuccessful because of an agent issue.
The File System restore was unsuccessful because a Status code 500 error occurred during the request to the Agent host.
Perform the operation again.
File sparseness and Linux file-level restores
Linux file-level restores of file-level backups do not retain file sparseness.
Use the appropriate tools to reduce disk space.
Restores of clustered drives fail with an agent host timed out error or a network connectivity error
When attempting to restore a clustered drive, you might see an error similar to one of the following:
The File System restore was unsuccessful because the request to the Agent host timed out.
ARA0005: Unable to restore FILE_SYSTEM asset C:\ClusterStorage\Volume3 because of a network connectivity issue on agent host w2019c2.agent.com.
The restore was unsuccessful because of an issue with the network connection.
To resolve this issue: 1.Check the network connectivity between PowerProtect Data Manager and the agent host. 2.Confirm that there is no packet loss between PowerProtect Data Manager and the agent host.
Perform a full discovery of the logical cluster host, and then retry the restore. For more information about performing a full discovery, see the
PowerProtect Data Manager Administrator Guide.
Restoring block-based backups on 16 TB ReFS volumes
Image-level restore operations of File System agent block-based backups (BBB) might fail ReFS volumes with 16 TB or higher capacity.
Restore the data by using file-level restore (FLR).
Restoring multiple backups or SSIDs from the command-line interface
A single-level restore command-line interface (CLI) cannot be used to select multiple backups or SSIDs for restore.
Open a separate file-level restore CLI for each backup or SSID.
XFS restores of block-based backups
When performing an XFS restore of a block-based backup on a remote host, the kernel version of the remote host must be equal to or higher than the kernel version of the source host.
There is no workaround.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\