Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

PowerProtect Data Manager 19.14 File System User Guide

Update the File System agent on Linux

The File System agent supports a direct update from an earlier version if you are using an earlier version of PowerProtect Data Manager. You can update the PowerProtect Data Manager File System agent on supported Linux systems in silent mode.

Update and register the latest version of the PowerProtect Data Manager File System agent for Linux with the same PowerProtect Data Manager server in the same location.

NOTE:A reboot is not required after the completion of the software update.
To update the File System agent on Linux, run the following command:
install.sh
  • For silent update in debugging mode, type: install.sh --force-upgrade --debug

    NOTE:During silent installation or update, the debug output is directed to syslog to be viewed later.
  • To enable the PowerProtect Data Manager communication 7000 TCP port, run the /opt/dpsapps/agentsvc/configfw.sh script as the root user.
NOTE:
  • When you install or update the File System agent, other app agents on the system must be updated to the same version as the File System agent.
  • Following an update, the first block-based backup is promoted to a full backup.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\