- Notes, cautions, and warnings
- Preface
- PowerProtect Data Manager for Network-Attached Storage Overview
- PowerProtect Data Manager overview
- Additional procedures for system administrators
- NAS appliance protection prerequisites
- NAS protection limitations
- Resolved limitations
- NAS protection deployment recommendations
- Encryption in-flight
- Roadmap for NAS protection
- Multiple VLAN support for NAS
- Supported Internet Protocol versions
- Security configuration
- Managing Assets and Protection
- About NAS protection
- Enable the NAS asset source
- Add a NAS appliance
- Add a NAS share
- Assets configuration support for DNAS
- Edit or delete a NAS asset source
- Discovering and adding PowerScale configured with SmartConnect and multiple access zones
- Deploy a protection engine for NAS asset protection
- Add a centralized protection policy for NAS assets
- Protection rules
- Extended retention for protection policies created in PowerProtect Data Manager 19.11 or earlier
- Exclusion filters for NAS
- Restore a NAS asset to the original location
- Restore a NAS asset to an alternate location
- NAS file level restore using File Search
- Restore PowerScale top-level path and permissions
- Protection engine parameters
- Determine protection engine usage for a protection job
- Change the protection engine Docker network range
- Network-Attached Storage Best Practices and Troubleshooting
- Glossary
PowerProtect Data Manager 19.14 Network-Attached Storage User Guide
Change the priority of an existing protection rule
When multiple protection rules exist, you can define the priority of each rule. Priority determines which rule applies to an asset when that asset matches multiple rules and those rules have conflicting actions.
About this task
For example, if an asset matches several protection rules and each rule specifies a different protection policy, then the rule with the highest priority determines the policy assignment.
Protection rule priorities are integers. Smaller integers represent a higher priority.
Steps
-
Select
.
The Protection Rules window appears.
-
To change a protection rule's priority, select the rule and then click
Up
or
Down.
Remember that the smaller integer has the higher priority.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\