- Notes, cautions, and warnings
- Preface
- PowerProtect Data Manager for Network-Attached Storage Overview
- PowerProtect Data Manager overview
- Additional procedures for system administrators
- NAS appliance protection prerequisites
- NAS protection limitations
- Resolved limitations
- NAS protection deployment recommendations
- Encryption in-flight
- Roadmap for NAS protection
- Multiple VLAN support for NAS
- Supported Internet Protocol versions
- Security configuration
- Managing Assets and Protection
- About NAS protection
- Enable the NAS asset source
- Add a NAS appliance
- Add a NAS share
- Assets configuration support for DNAS
- Edit or delete a NAS asset source
- Discovering and adding PowerScale configured with SmartConnect and multiple access zones
- Deploy a protection engine for NAS asset protection
- Add a centralized protection policy for NAS assets
- Protection rules
- Extended retention for protection policies created in PowerProtect Data Manager 19.11 or earlier
- Exclusion filters for NAS
- Restore a NAS asset to the original location
- Restore a NAS asset to an alternate location
- NAS file level restore using File Search
- Restore PowerScale top-level path and permissions
- Protection engine parameters
- Determine protection engine usage for a protection job
- Change the protection engine Docker network range
- Network-Attached Storage Best Practices and Troubleshooting
- Glossary
PowerProtect Data Manager 19.14 Network-Attached Storage User Guide
Exclusion filters for NAS
Exclusion filters enable you to exclude certain files and folders from protection, based on the filter's conditions (conditions for exclusion).
Use the PowerProtect Data Manager UI to add, edit, and delete exclusion filters for NAS files and folders.
When you create or edit a protection policy, you can apply exclusion filters to the protection policy.
When an exclusion filter is applied to a protection policy, the NAS agent performs backups of the protected assets. Adding exclusion filter to a protection policy can increase the overall backup time.
NOTE:By default, snapshot folders such as
~snapshot,
.snapshot and the folders in the
.ckpt_ format are excluded from backup and slicing.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\