PowerProtect Data Manager 19.14 SAP HANA User Guide

PDF

Disable the SAP HANA agent

Learn how to disable the SAP HANA agent.

You disable the agent running the command ./unregister.sh --full_decommission from the directory where the agent service is installed.

After you disable the agent from PowerProtect Data Manager, the agent software binary remains on the client host. You can configure the client host as a stand-alone agent by following the instructions in the PowerProtect Database Application Agent Installation and Administration Guide. Information about the previous DD setup is located under the directory /usr/sap/<SID>/SYS/global/ppdmconfig.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\