Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

PowerProtect Data Manager 19.14 SAP HANA User Guide

Enable multi-stream backups for SAP HANA protection policy

To enable multi-stream SAP HANA backups for a centralized protection policy, you can set the parallelism value in the PowerProtect Data Manager UI. The parallelism value controls the number of parallel streams that the SAP HANA agent uses to write the backup data to DD.

NOTE:

As an SAP requirement to enable multiple streams for SAP HANA databases, the protected data size must be 128 GB or greater. You must also enable the multi-stream SAP HANA backups with PowerProtect Data Manager and configure the parallel streams in SAP HANA. The SAP HANA documentation provides the latest information about the requirement for multiple streams.

For self-service backups, you must set the parallelism value through the PARALLELISM parameter as described in Modify the configuration file parameter settings.

Use the following guidelines to set the parallelism value in the PowerProtect Data Manager UI:

  • Set the parallelism to a value that is equal to or very close to the parallel_data_backup_backint_channels parameter setting. When the two settings are equal or almost equal, the SAP HANA agent can take full advantage of the parallelism provided by SAP HANA.
  • Set the parallelism to a value that is not more than the maximum number of connections provided by DD.
  • Set the parallelism to a value that is at least 3 less than the maximum number of connections provided by DD. Reserve 3 connections for the log backups. For example, when DD can provide a maximum of 10 connections, set the parallelism value to 7 (10 minus 3).

In the PowerProtect Data Manager UI, perform the following steps to set the parallelism for multi-stream backups:

  1. Select Infrastructure > Assets > SAP HANA.
  2. Select the SAP HANA asset.
  3. Select More Actions > Set Stream Count.
  4. Set the stream count for each backup level as a value between 1 and 28 in the Full, Differential, and Incremental fields.
  5. Click Save.
NOTE:To control the number of data pipes provided by SAP HANA, you can set the parameter parallel_data_backup_backint_channels in SAP HANA Studio.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\