PowerProtect Data Manager 19.14 SAP HANA User Guide

PDF

Performing recovery by using the SAP HANA CLI in an MDC system

To recover an SAP HANA MDC database with the SAP HANA CLI, you must log in to the SAP HANA SYSTEMDB database and run the required recover command.

For example, run the following command to recover the database application agent backup of an SAP HANA MDC database: 

RECOVER DATABASE FOR DB0 UNTIL TIMESTAMP '2015-08-29 01:25:25' USING DATA PATH ('/usr/sap/AAA/SYS/global/hdb/backint/DB_DB0/') USING LOG PATH ('/usr/sap/AAA/HDB00/backup/log/DB_DB0') USING BACKUP_ID 1440811502099 CHECK ACCESS USING BACKINT

The SAP HANA Administration Guide provide details about the recover command and procedures in an SAP HANA MDC system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\