Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

PowerProtect Data Manager 19.14 SAP HANA User Guide

Start, stop, or obtain the status of the PowerProtect agent service

The PowerProtect agent service is started during the agent installation by the installer. If needed, you can use the appropriate procedure to start, stop, or obtain the status of the agent service.

On AIX or Linux, you can start, stop, or obtain the status of the agent service by running the register.sh script that is found in the <agent_service_installation_location> directory.

  • To start the agent service:

    # register.sh --start
    
    Started agent service with PID - 1234

    Alternatively on Linux, you can use the following command to start the agent service:

    # service agentsvc start
  • To stop the agent service:

    # register.sh --stop
    
    Successfully stopped agent-service.

    Alternatively on Linux, you can use the following command to stop the agent service:

    # service agentsvc stop
  • To obtain the status when the agent service is running:

    # register.sh --status
    
    Agent-service is running with PID - 1234
  • To obtain the status when the agent service is not running:

    # register.sh --status
    
    Agent-service is not running.
  • Alternatively on Linux, you can use the following command to obtain the status of the agent service when it is running or not running:
    # service agentsvc status

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\