- Notes, cautions, and warnings
- Preface
- PowerProtect Data Manager for SAP HANA Agent Overview
- Enabling the SAP HANA Agent
- SAP HANA data protection and replication requirements
- Protecting a stand-alone SAP HANA server
- Protecting SAP HANA multinode environments
- Install and configure the SAP HANA agent
- Install the SAP HANA agent
- Update the SAP HANA agent
- Update the application agent in the PowerProtect Data Manager UI
- Uninstall the SAP HANA agent
- Configure the SAP HANA operations
- Integrate the SAP HANA backup program
- Modify the configuration file parameter settings
- Enable the discovery of database application agent backups
- Configure support of SAP HANA 2.0
- Configure automatic backups of SAP HANA logs
- Configure the SAP HANA parallel backup setting
- Enable multi-stream backups for SAP HANA protection policy
- Deploy the SAP HANA agent in Microsoft Azure environment
- Manage the SAP HANA application agent
- Managing Storage, Assets, and Protection
- Add protection storage
- Enable an asset source
- Delete an asset source
- Discover an SAP HANA application host
- Add and remove the credentials for SAP HANA assets
- Replication triggers
- Add a protection policy for SAP HANA database protection
- Protection rules
- Cancel a Microsoft Exchange, Oracle, or SAP HANA application agent protection job
- Extended retention for protection policies created in PowerProtect Data Manager 19.11 or earlier
- Edit the retention period for backup copies
- Delete backup copies
- Enable the SAP HANA agent after hostname change
- Enable the SAP HANA agent after host IP address change
- Migrate the SAP HANA agent to a different host
- Migrate the SAP HANA agent to a different PowerProtect Data Manager server
- Manage the PowerProtect agent service
- Manage the cloud tier operations with PowerProtect Data Manager for application agents
- Performing Self-Service Backups of SAP HANA Databases
- Performing self-service backups of SAP HANA databases
- Restore an SAP HANA application host
- Displaying the restore progress in PowerProtect Data Manager UI
- Performing restore and recovery by using SAP HANA Studio
- Performing restore with dependency chaining or replication storage
- Performing alternate host recovery
- Performing restore of backups performed prior to PowerProtect Data Manager registration
- Performing recovery by using the SAP HANA CLI
- SAP HANA Best Practices and Troubleshooting
- Glossary
PowerProtect Data Manager 19.14 SAP HANA User Guide
Troubleshooting storage units
Review the following issues related to storage units in PowerProtect Data Manager.
Creating storage unit fails when maximum MTree and Users count on DD system reached
When you add a protection policy or create a storage unit in PowerProtect Data Manager, storage unit creation fails if you reach the maximum MTree and Users count on the selected DD system. PowerProtect Data Manager enables you to finish adding a protection policy without a storage unit. However, if you subsequently run a backup with this protection policy, the backup process is suspended indefinitely with no error message.
To continue backup operations, you must perform a cleanup on the DD system.
Discrepancy between storage unit capacity reported in PowerProtect Data Manager and DD Virtual Edition
Due to differences in space calculation (physical capacity vs. logical capacity), there is a discrepancy between storage unit capacity reported in PowerProtect Data Manager and DD Virtual Edition. For example, the DD storage unit capacity displayed in the window of the PowerProtect Data Manager UI might be greater than the amount displayed in DDVE.
To determine storage unit capacity, use DDVE instead.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\