- Notes, cautions, and warnings
- Preface
- Getting Started
- Preparing for a Deployment
- Deployment
- Configuration
- Glossary
PowerProtect Data Manager 19.15 Amazon Web Services Deployment Guide
Configure network traffic rules
Configure network traffic rules to restrict inbound and outbound connections.
About this task
CAUTION:Do not use IP addresses that belong to the 172.24.0.192/26 subnet. IP addresses in the 172.24.0.192–172.24.0.255 range are used for Docker network configuration, and unexpected results can occur if they are also used by
PowerProtect Data Manager.
Steps
- From the EC2 Instance Management Console, click the security group shown after Security groups, and select either or .
- From either the Edit inbound rules pane or the Edit outbound rules pane, change specific network traffic rules.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\