Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

PowerProtect Data Manager 19.15 Kubernetes User Guide

Identifying a remote system

Remote systems added to PowerProtect Data Manager for quick recovery can be identified using either a fully qualified domain name (FQDN) or an IP address. If incorrectly identified, quick recovery fails with a certificate error.

If a remote system is already identified in the PowerProtect Data Manager certificate list, it must be added to PowerProtect Data Manager for quick recovery with the same identification.

If you always use either FQDNs or IP addresses for all remote systems, do the same for quick recovery.

If a certificate entry for a remote system exists, you must use the same identification when adding it for quick recovery. If you are unsure if a remote system you want to add for quick recovery is already in the PowerProtect Data Manager certificate list, perform the following steps:

  • Log in to the console as the root user.
  • Type keytool -list -keystore.
  • Review the output and look for a certificate entry that corresponds to either the FQDN or IP address of the remote system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\