Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

PowerProtect Data Manager 19.15 SAP HANA User Guide

Performing restore and recovery by using SAP HANA Studio

  1. Start SAP HANA Studio.
  2. In the recovery GUI, go to the Specify Recovery Type page.

    Figure 1. Specifying the recovery type in SAP HANA Studio
    Specifying the recovery type in SAP HANA Studio
    1. Select one of the following types of recovery for the required SID:
      • Recover the database to its most recent state—Recovers the database as close as possible to the current time.
      • Recover the database to the following point in time—Recovers the database to a specific point-in-time.
      • Recover the database to a specific data backup—Restores only the specified data backup.
    2. In an exceptional case when a previous recovery has failed, click Advanced >>, and then select Recover the database to the following log position.
    3. Click Next >.
  3. On the Locate Log Backups page, specify the locations of the log backup files to use to perform recovery.

    The backup locations for the single database containers and the multitenant database containers are as follows:

    • Single database container—/usr/sap/<SID>/SYS/global/hdb/backint/
    • Multitenant database container (System DB)—/usr/sap/<SID>/SYS/global/hdb/backint/SYSTEMDB
    • Multitenant database container (Tenant DB)—/usr/sap/<SID>/SYS/global/hdb/backint/DB_<tenantDB>
    Figure 2. Locating the log backups in SAP HANA Studio
    Locating the log backups in SAP HANA Studio
  4. On the Select Data Backup page, select the database backup for either restore or recovery.
    Figure 3. Selecting the data backup in SAP HANA Studio
    Selecting the data backup in SAP HANA Studio

    To check the availability of a backup, select the backup in the table, and then click Check Availability. The Available column in the table displays either a green icon if the backup is available or a red icon if the backup is not available.

  5. On the Other Settings page, select the required options, and then click Next >.
  6. On the Review Recovery Settings page, review the information, and then click Finish.

    The recovery progress appears for each service that includes the name server, the index server, and the statistics server. A confirmation message appears when the recovery completes.


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\