PowerProtect Data Manager 19.16 Azure Deployment Guide

PDF

Configure network traffic rules

Configure network traffic rules to restrict inbound and outbound connections.

About this task

CAUTION:Do not use IP addresses that belong to the 172.24.0.192/26 subnet. IP addresses in the 172.24.0.192–172.24.0.255 range are used for Docker network configuration, and unexpected results can occur if they are also used by PowerProtect Data Manager.

Steps

  1. From the Azure portal, navigate to Home > Virtual machines, and click the entry for the PowerProtect Data Manager virtual appliance.
  2. From the pane for the virtual appliance, click Networking.
  3. From the Network Interface pane, click either Inbound port rules or Outbound port rules, and change specific network traffic rules.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\