- Notes, cautions, and warnings
- Preface
- PowerProtect Data Manager for Storage Arrays Overview
- Managing Assets and Protection
- About asset sources, assets, and storage
- Enable the storage array asset source
- Add a storage array
- Edit a storage array asset source
- Delete a storage array asset source
- Protection policies for block volume protection
- Supported protection policy purposes
- Supported protection policy objectives
- Replication triggers
- Roadmap for planning a protection policy
- Before you add a protection policy for block volume protection
- Add a protection policy for block volume protection
- Change the password of the new target storage user (PowerStore block volume type policy only)
- Create a manual snapshot
- Protection rules
- Restoring block volume data
- Restore a block volume using Instant Access
- Troubleshooting
- Glossary
PowerProtect Data Manager 19.16 Storage Array User Guide
Delete a storage array asset source
Perform the following procedure to delete a storage array asset source.
Prerequisites
Before deleting a storage array asset source, ensure that no backup or restore activities are running for any assets on the storage array.
CAUTION:If there are backups or restores running when the asset source is deleted, the protection operations fail.
Steps
- Log in to the PowerProtect Data Manager user interface as a user with the Administrator role.
-
From the left navigation pane, select
.
The Asset Sources window appears.
-
Click the
Storage Arrays tab.
The list of configured storage array asset sources appears.
-
Select the asset source and then click
Delete.
PowerProtect Data Manager warns you to remove associated assets from protection policies. Click OK to acknowledge the warning.
PowerProtect Data Manager removes the selected asset source.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\