- Notes, cautions, and warnings
- Preface
- PowerProtect Data Manager for Storage Arrays Overview
- Managing Assets and Protection
- About asset sources, assets, and storage
- Enable the storage array asset source
- Add a storage array
- Edit a storage array asset source
- Delete a storage array asset source
- Protection policies for block volume protection
- Supported protection policy purposes
- Supported protection policy objectives
- Replication triggers
- Roadmap for planning a protection policy
- Before you add a protection policy for block volume protection
- Add a protection policy for block volume protection
- Change the password of the new target storage user (PowerStore block volume type policy only)
- Create a manual snapshot
- Protection rules
- Restoring block volume data
- Restore a block volume using Instant Access
- Troubleshooting
- Glossary
PowerProtect Data Manager 19.16 Storage Array User Guide
Manually run a protection rule
PowerProtect Data Manager automatically runs protection rules when new assets are detected or when existing assets are modified. You can also run protection rules manually.
Prerequisites
NOTE: For SQL, Oracle, SAP HANA, file system, and block volume asset types, the protection rule runs only on scheduled discovery in
PowerProtect Data Manager. Ensure that you schedule discovery for these asset types.
Steps
-
From the
PowerProtect Data Manager UI, select
.
The Protection Rules window appears.
-
Select the required protection rules, and then click
Run.
PowerProtect Data Manager runs all of the selected protection rules for the current asset type.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\