- Notes, cautions, and warnings
- Preface
- PowerProtect Data Manager for Storage Arrays Overview
- Managing Assets and Protection
- About asset sources, assets, and storage
- Enable the storage array asset source
- Add a storage array
- Edit a storage array asset source
- Delete a storage array asset source
- Protection policies for block volume protection
- Supported protection policy purposes
- Supported protection policy objectives
- Replication triggers
- Roadmap for planning a protection policy
- Before you add a protection policy for block volume protection
- Add a protection policy for block volume protection
- Change the password of the new target storage user (PowerStore block volume type policy only)
- Create a manual snapshot
- Protection rules
- Restoring block volume data
- Restore a block volume using Instant Access
- Troubleshooting
- Glossary
PowerProtect Data Manager 19.16 Storage Array User Guide
Restoring block volume data
When data in volumes or volume groups is backed up as part of a crash consistent protection policy in PowerProtect Data Manager, you can restore the backups by using the centralized restore functionality in the PowerProtect Data Manager UI.
NOTE:Restore of an individual volume from a volume group backup is not supported.
You can perform the following types of centralized restores of volumes and volume groups:
- Restore data from primary or replicated backups to the original block volume
- Restore data from primary or replicated backups to an alternate block volume on the same or different storage array
- Restore data from a snapshot to the original location
- Refresh data on a clone using a snapshot
- Instant Access
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\