- Notes, cautions, and warnings
- Preface
- PowerProtect Data Manager for Storage Arrays Overview
- Managing Assets and Protection
- About asset sources, assets, and storage
- Enable the storage array asset source
- Add a storage array
- Edit a storage array asset source
- Delete a storage array asset source
- Protection policies for block volume protection
- Supported protection policy purposes
- Supported protection policy objectives
- Replication triggers
- Roadmap for planning a protection policy
- Before you add a protection policy for block volume protection
- Add a protection policy for block volume protection
- Change the password of the new target storage user (PowerStore block volume type policy only)
- Create a manual snapshot
- Protection rules
- Restoring block volume data
- Restore a block volume using Instant Access
- Troubleshooting
- Glossary
PowerProtect Data Manager 19.16 Storage Array User Guide
Select a protection policy purpose
Select from the list of supported purposes.
Steps
On the
Purpose page, select one of the following options to indicate the purpose of the new protection policy group, and then click
Next:
- Crash Consistent—PowerProtect Data Manager takes a snapshot of the virtual asset as it appears in storage at the beginning of the backup to ensure point-in-time protection. This snapshot includes all disks (VMDKs) that are part of the virtual machine backup.
- Exclusion—Marks the specified assets as intentionally exempt from data protection operations. Otherwise, assets that are not assigned to any protection policy are reported as unprotected. PowerProtect Data Manager restricts the specified assets from being assigned to other protection policies.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\