- Notes, cautions, and warnings
- Preface
- PowerProtect Data Manager for Storage Arrays Overview
- Managing Assets and Protection
- About asset sources, assets, and storage
- Enable the storage array asset source
- Add a storage array
- Edit a storage array asset source
- Delete a storage array asset source
- Protection policies for block volume protection
- Supported protection policy purposes
- Supported protection policy objectives
- Replication triggers
- Roadmap for planning a protection policy
- Before you add a protection policy for block volume protection
- Add a protection policy for block volume protection
- Change the password of the new target storage user (PowerStore block volume type policy only)
- Create a manual snapshot
- Protection rules
- Restoring block volume data
- Restore a block volume using Instant Access
- Troubleshooting
- Glossary
PowerProtect Data Manager 19.16 Storage Array User Guide
Select a protection policy type
Open the Add Policy wizard and select the protection policy type.
Steps
-
From the left navigation pane, select
.
The Protection Policies window appears.
-
In the
Protection Policies window, click
Add.
The Add Policy wizard appears.
-
On the
Type page, specify the following fields, and then click
Next:
- Name—Type a descriptive name for the protection policy.
- Description—Type a description for the policy.
- Type—Select Block Volume.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\