- Notes, cautions, and warnings
- Preface
- PowerProtect Data Manager for Storage Arrays Overview
- Managing Assets and Protection
- About asset sources, assets, and storage
- Enable the storage array asset source
- Add a storage array
- Edit a storage array asset source
- Delete a storage array asset source
- Protection policies for block volume protection
- Supported protection policy purposes
- Supported protection policy objectives
- Replication triggers
- Roadmap for planning a protection policy
- Before you add a protection policy for block volume protection
- Add a protection policy for block volume protection
- Change the password of the new target storage user (PowerStore block volume type policy only)
- Create a manual snapshot
- Protection rules
- Restoring block volume data
- Restore a block volume using Instant Access
- Troubleshooting
- Glossary
PowerProtect Data Manager 19.16 Storage Array User Guide
Select protection policy assets
Steps
-
On the
Assets page, select the unprotected assets that you want to add to the backup of this protection policy.
The window enables you to filter by asset name to locate the required assets.
- Click Next.
Results
For exclusion policies, the wizard moves to the Summary page. Continue to Review the protection policy summary.
For all other policy purposes, the wizard moves to the Objectives page. Continue to Add protection policy objectives.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\