PowerProtect Data Manager 19.17 Storage Array User Guide
Create a manual snapshot (PowerStore)
For a PowerStore block volume asset that is protected by a policy with a snapshot objective, you can create a single snapshot of the asset by using the Take Snapshot functionality.
About this task
Snapshots are read-only, point-in-time copies of data within a volume or volume group that provide local data protection. Creating a snapshot saves the state of the asset at that particular point-in-time.
Steps
-
From the left navigation pane, select
.
The Assets window appears.
-
Select the
PowerStore Block Volumes tab.
The list of block volume assets appears.
-
Select a block volume asset from the list, and then click
Take Snapshot.
You must select an asset that belongs to a protection policy with a configured snapshot objective.
Results
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\