Dell EMC PowerSwitch S3048-ON Installation Guide March 2021


AC power supply replacement

CAUTION: Disconnect the power cord before removing the power supplies. Also, disconnect all power cords before servicing.
NOTE: The PSU slides into the slot smoothly. Do not force a PSU into a slot as this action may damage the PSU or the S3048–ON chassis.
NOTE: If a PSU fails, you must replace the entire unit. There are no field serviceable components in the PSU.
NOTE: If you use a single PSU, install a blank plate in the other PSU slot. If you are only using one power supply, Dell EMC recommends installing the power supply in the first slot (PSU1) and installing a blank plate in the second slot (PSU2).
  1. Disconnect the power cable from the PSU.
  2. Use the grab handle to slide the PSU out of the power supply bay.
  3. Use the grab handle on the replacement PSU to slide it into the power supply bay.
  4. Attach the power cord to the replacement PSU.
    NOTE: The switch powers up when you connect the cables between the power supply and the power source.

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\