Dell EMC PowerSwitch S3048-ON Installation Guide March 2021

PDF

Install the S3048–ON

To install the S3048–ON switch, complete the installation procedures in the order presented in this chapter.

Always handle the S3048–ON and its components with care. Avoid dropping the switch or its field replaceable units (FRUs).

This chapter describes the installation procedures as follows:

  1. Unpack
  2. Rack or cabinet hardware installation
  3. Switch installation
  4. Optics installation
  5. Power up the switch
NOTE: ESD damage can occur if components are mishandled. Always wear an ESD-preventive wrist or heel ground strap when handling the S3048–ON and its components. As with all electrical devices of this type, take all the necessary safety precautions to prevent injury when installing this switch.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\