Dell EMC PowerSwitch S3048-ON Installation Guide March 2021

PDF

USB-B console port access

The USB-B console port is on the I/O side of the S3048-ON.

When you connect the USB-B port, it becomes the primary connection and, while connected, all messages are sent to the USB-B port.

To access the USB-B console port, follow these steps.

  1. Power on the PC.
  2. Connect the USB-A end of cable into an available USB port on the PC.
  3. Connect the USB-B end of cable into the USB-B console port on the S3048-ON.
  4. Power on the S3048-ON.
  5. Install the necessary USB device drivers.
  6. Open your terminal software emulation program to access the S3048-ON.
  7. Confirm the terminal settings on your terminal software emulation program are as follows:
    • 115200 baud rate
    • No parity
    • 8 data bits
    • 1 stop bit
    • No flow control

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\