OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

Access-list to match route-map

You can assign an IPv4 or IPv6 access-list to match a route-map.

The IP access list contains the criteria to match the traffic content based on the header field, such as destination IP or source IP.

When permit or deny is present in the access-list, it is omitted and the action present in the route-map command is used for policy-based routing. permit in the route-map statement indicates policy-based routing, as where deny in the route-map statement indicates a switch-based forwarding decision—PBR exception. Access-list is used only for the packet match criteria in policy-based routing.

  1. Assign an access-list to match the route-map in CONFIGURATION mode.
    ip access-list 
                                           access-list-name
                                        
  2. Set the IP address to match the access-list in IP-ACL mode.
    permit ip 
                                           ip-address
                                        
Configure IPv4 access-list to match route-map
OS10(config)# ip access-list acl5
                                    OS10(conf-ipv4-acl)# permit ip 10.10.10.0/24 any
                                 
Configure IPv6 access-list to match route-map
OS10(config)# ipv6 access-list acl8
                                    OS10(conf-ipv6-acl)# permit ipv6 10::10 any
                                 

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\