OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

allowas-in

Sets the number of times a local AS number appears in the AS path.

Syntax
allowas-in as-number
Parameters
as-number —Enter the number of occurrences for a local AS number, from 1 to 10.
Default
Disabled
Command Mode
ROUTER-BPG-TEMPLATE-AF
Usage Information
Use this command to enable the BGP speaker to allow the AS number to be present for the specified number of times in updates received from the peer. You cannot set this configuration for a peer associated with a peer group. You cannot associate a peer to a peer group that is already configured with an AS number. The no version of this command resets the value to the default.
Example ((IPv4)
OS10(conf-router-template)# address-family ipv4 unicast
                                       OS10(conf-router-bgp-template-af)# allowas-in 5
                                    
Example (IPv6)
OS10(conf-router-template)# address-family ipv6 unicast
                                       OS10(conf-router-bgp-template-af)# allowas-in 5
                                    
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\