OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

Assigning a loopback interface to a non-default VRF instance

After creating a non-default VRF instance you can associate a loopback interface to the VRF instance that you created.

To assign a loopback interface to a non-default VRF, perform the following steps:

  1. Enter the loopback interface that you want to assign to a non-default VRF instance. CONFIGURATION interface loopback 5
  2. Remove the interfacet from L2 switching. INTERFACE no switchport
  3. Assign the interface to a non-default VRF. INTERFACE CONFIGURATION ip vrf forwarding vrf-test Before assigning a n interface to a VRF instance, ensure that no IP address is configured on the interface.
  4. Assign an IPv4 address to the interface. INTERFACE CONFIGURATION ip address 10.1.1.1/24
  5. Assign an IPv6 address to the interface. INTERFACE CONFIGURATION ipv6 address 1::1/64 You can also auto configure an IPv6 address using the ipv6 address autoconfig command.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\