OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

BFD configuration

Before you configure BFD for a routing protocol, first enable BFD globally on both routers in the link. BFD is disabled by default.
  • OS10 supports:
    • 64 BFD sessions at 100 minimum transmit and receive intervals with a multiplier of 4
    • 100 BFD sessions at 200 minimum transmit and receive intervals with a multiplier of 3
  • OS10 does not support Demand mode, authentication, and the Echo function.
  • OS10 does not support BFD on multi-hop and virtual links.
  • OS10 supports protocol liveness only for routing protocols.
  • OS10 BFD supports only the BGP routing protocol. For IPv4 and IPv6 BGP, OS10 supports only the default VRF.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\