OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

boot system

Sets the boot partition to use during the next reboot.

Syntax
boot system {active | standby}
Parameters
  • active — Reset the running partition as the next boot partition.
  • standby — Set the standby partition as the next boot partition.
Default
Active
Command Mode
EXEC
Usage Information
Use this command to configure the location of the OS10 image used to reload the software at boot time. Use the show boot command to view the configured next boot image. This command is applied immediately and does not require the commit command.
Example
OS10# boot system standby
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\