OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

Broadcasts

Receive broadcasts of time information and set interfaces within the system to receive NTP information through broadcast. NTP is enabled on all active interfaces by default. If you disable NTP on an interface, the system drops any NTP packets sent to that interface.

  1. Set the interface to receive NTP packets in INTERFACE mode.
    ntp broadcast client
  2. Disable NTP on the interface in INTERFACE mode.
    ntp disable

Configure NTP broadcasts

OS10(config)# interface ethernet 1/1/10
                                 OS10(conf-if-eth1/1/10)# ntp broadcast client
                              

Disable NTP broadcasts

OS10(config)# interface ethernet 1/1/10
                                 OS10(conf-if-eth1/1/10)# ntp disable
                              

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\