OS10 Enterprise Edition User Guide Release


Change hash algorithm

The load-balancing command selects the hash criteria applied to load balancing of traffic on port-channels. If you do not obtain even traffic distribution, use the hash-algorithm command to select the hash scheme for LAG. Rotate or shift the L2-bit LAG hash until the desired traffic distribution is achieved.

  • Change the default ( 0) to another algorithm and apply it to LAG hashing in CONFIGURATION mode.
    hash-algorithm lag 
Change hash algorithm
OS10(config)# hash-algorithm lag crc 

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\