OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

clear ip bgp *

Resets BGP sessions. The soft parameter (BGP soft reconfiguration) clears policies without resetting the TCP connection.

Syntax
clear ip bgp * [vrf vrf-name] [ipv4 unicast | ipv6 unicast | soft [in | out]]
Parameters
  • * — Enter to clear all BGP sessions.
  • vrf vrf-name — (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to clear BGP session information corresponding to that VRF.
  • ipv4 unicast — Enter to clear IPv4 unicast configuration.
  • ipv6 unicast — Enter to clear IPv6 unicast configuration.
  • soft — (Optional) Enter to configure and activate policies without resetting the BGP TCP session — BGP soft reconfiguration.
  • in — (Optional) Enter to activate only ingress (inbound) policies.
  • out — (Optional) Enter to activate only egress (outbound) policies.
Default
Not configured
Command Mode
EXEC
Usage Information
Use this command to reset BGP sessions.
Example
OS10# clear ip bgp * ipv6 unicast
Supported Releases
10.3.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\