OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

Configure Border Gateway Protocol

BGP is disabled by default. To enable the BGP process and start to exchange information, assign an AS number and use commands in ROUTER-BGP mode to configure a BGP neighbor.

BGP neighbor adjacency changes
All BGP neighbor changes are logged
Fast external fallover
Enabled
Graceful restart
Disabled
Local preference
100
4-byte AS
Enabled
MED
0
Route flap dampening parameters
  • half-life = 15 minutes
  • max-suppress-time = 60 minutes
  • reuse = 750
  • suppress = 2000
Timers
  • keepalive = 60 seconds
  • holdtime = 180 seconds
Add-path
Disabled

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\