OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

Configure Management IP address

To remotely access OS10, assign an IP address to the management port. The management interface is used for OOB management purposes.

  1. Configure the management interface from CONFIGURATION mode.
    interface mgmt 1/1/1
  2. By default, DHCP client is enabled on the Management interface. Disable the DHCP client operations in INTERFACE mode.
    no ip address dhcp
  3. Configure an IPv4 or IPv6 address on the Management interface in INTERFACE mode.
    ip address 
                                        A.B.C.D/mask
                                     
    ipv6 address 
                                        A:B/prefix-length
                                     
  4. Enable the Management interface in INTERFACE mode.
    no shutdown

Configure Management interface

OS10(config)# interface mgmt 1/1/1
                              OS10(conf-if-ma-1/1/1)# no ip address dhcp
                              OS10(conf-if-ma-1/1/1)# ip address 10.1.1.10/24
                              OS10(conf-if-ma-1/1/1)# no shutdown
                           

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\