OS10 Enterprise Edition User Guide Release


Configure remote port monitoring

Remote port monitoring requires a source interface (monitored ports on different source network devices) and a reserved tagged VLAN for transporting mirrored traffic (configured on the source, intermediate, and destination devices).

  1. Create a remote monitoring session in CONFIGURATION mode.
    monitor session 
                                        session-id type rpm-source
  2. Enter the source to monitor traffic in MONITOR-SESSION mode.
    source interface 
  3. Enter the destination to send the traffic to in MONITOR-SESSION mode.
    destination remote-vlan 
  4. Enable the monitoring interface in MONITOR-SESSION mode.
    no shut

Create remote monitoring session

OS10(config)# monitor session 10 type rpm-source

Configure source and destination port, and traffic direction

OS10(conf-mon-rpm-source-10)# source interface vlan 10 rx
                              OS10(conf-mon-rpm-source-10)# destination remote-vlan 100
                              OS10(conf-mon-rpm-source-10)# no shut

View monitoring session

OS10(conf-mon-rpm-source-10)# do show monitor session all
                              S.Id  Source  Destination Dir SrcIP DstIP DSCP TTL  State Reason
                              1     vlan10  vlan 100   rx   N/A   N/A   N/A  N/A  true  Is UP

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\