OS10 Enterprise Edition User Guide Release


Create virtual router

VRRP uses the VRID to identify each virtual router configured. Before using VRRP, you must configure the interface with the primary IP address and enable it.

  • Create a virtual router for the interface with the VRRP identifier in INTERFACE mode (1 to 255).
  • Delete a VRRP group in INTERFACE mode.
    no vrrp-group 

Configure VRRP

OS10(config)# interface ethernet 1/1/5
                                 OS10(conf-if-eth1/1/5)# vrrp-group 254

Verify VRRP

OS10(conf-eth1/1/5-vrid-254)# do show running-configuration
                                 interface ethernet 1/1/5 
                                 ip address
                                 vrrp-group 254 
                                 no shutdown

Rate this content

Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\