OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

Create VLT domain

A VLT domain requires an ID number. Configure the same VLT domain ID on both peers, see VLT domain. The no vlt-domain command disables VLT.

  1. Configure a VLT domain and enter VLT-DOMAIN mode. Configure the same VLT domain ID on each peer, from 1 to 255.
    vlt-domain 
                                           domain-id
                                        
  2. Repeat the steps on the VLT peer to create the VLT domain.

Peer 1

OS10(config)# vlt-domain 1
                                 OS10(conf-vlt-1)#
                              

Peer 2

OS10(config)# vlt-domain 1
                                 OS10(conf-vlt-1)# 
                              

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\