OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

destination (Port Monitoring)

Sets the destination where monitored traffic is sent to. The monitoring session can be local or RPM.

Syntax
destination {interface interface-type | remote-vlan vlan-id }
Parameters
interface-type — Enter the interface type for a local monitoring session.
  • ethernet node/slot/port[:subport] — Enter the Ethernet interface information as the destination.
  • port-channel id-number — Enter a port-channel number as the destination (1 to 128).
  • vlan vlan-id —Enter a VLAN ID as the destination (1 to 4093).
remote-vlan vlan-id —Enter a remote VLAN ID as the destination for RPM monitoring session (1 to 4093).
Default
Not configured
Command Mode
MONITOR-SESSION
Usage Information
The no version of this command resets the value to the default.
Example
OS10(conf-mon-local-10)# destination interface port-channel 10
OS10(conf-mon-rpm-source-3)# destination remote-vlan 20
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\