OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

dot1x port-control

Controls the 802.1X authentication performed on the interface.

Syntax
dot1x port-control {force-authorized | force-unauthorized | auto}
Parameters
  • force-authorized — Disables 802.1X authentication on the interface and allows all traffic on the interface without authentication.
  • force-unauthorized — Keeps the port in unauthorized state, ignoring all attempts by the client to authenticate.
  • auto — Enables the 802.1X authentication on the interface.
Default
Force-authorized
Command Mode
INTERFACE
Usage Information
The no version of this command resets the value to the default.
Example
OS10(config)# interface range ethernet 1/1/7-1/1/8
                                       OS10(conf-range-eth1/1/7-1/1/8)# dot1x port-control auto
                                       
                                    
Supported Releases
10.2.0E or later

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\