OS10 Enterprise Edition User Guide Release 10.4.1.0

PDF

Enable energy-efficient Ethernet

To reduce power consumption, enable EEE. EEE is disabled by default.

  1. Enter the physical Ethernet interface information in CONFIGURATION mode.
    interface ethernet 
                                           node/slot/port[:subport]
                                        
  2. Enable EEE in INTERFACE mode.
    eee
Enable EEE
OS10(config)# interface ethernet 1/1/1
                                    OS10(conf-if-eth1/1/1)# eee
                                 
Disable EEE
OS10(config)# interface ethernet 1/1/1
                                    OS10(conf-if-eth1/1/1)# no eee
                                 

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\